A wooden alarm clock is an electronic alarm clock made of solid wood material. Its feature is to display the time on the solid wood interface. The setting method for a wooden alarm clock is generally included in the user manual that comes with the purchase, and the specific setting is similar to a regular electronic alarm clock:

1. Travel time and alarm settings

Insert the AC/DC adapter into the power supply, connect the 6V DC voltage plug to the clock 6V interface, and the LED digital screen will light up to display; Press and hold the SET key for 3 seconds to enter the setting mode, then press the SET key again. Each time you press the SET key, the year, month, day, hour, and minute will flash in sequence. To set the year, month, day, hour, and minute, simply change the flashing number. Press the UP and Down keys to adjust, and press the SET key to complete the setting.

2. Alarm time setting

Pressing the DOWN key will display AL: -- or AL: on on the display screen, and each time the DOWN key is pressed, it will switch once. Press and hold the DON key for 3 seconds, and when the number flashes, it can be adjusted using the UP and DON keys; To adjust the number of points, first press the SET key to switch to flashing points, and also use the UP and Down keys to adjust; Press the SET key to return the clock to its normal running state after setting is completed. When the alarm goes off, press the SET or UP button to stop the alarm and turn off the alarm function.

3. 12/24 hour clock setting

Under normal time display, pressing the UP button once can achieve a 1/4 hour conversion. In the 12 hour system, when the number reaches 12, a bright spot will appear in the upper left corner of the clock, indicating that it is already afternoon time.

2、 How to make a homemade wooden alarm clock

The wooden alarm clock looks quite tall and has a good decorative effect when placed at home. If you have strong hands-on ability, you can also choose a handmade DIY wooden alarm clock. The homemade method for making a wooden alarm clock is:

1. Preparation materials: art knife, ruler, small hand saw, water-based pen, pine wood strip, LCD clock microcontroller, light wood chip, charging USB cable.

2. Set the length, width, and height of the alarm clock according to the size of the LCD screen, mark the pine wood strip, and then use a small hand saw to cut it off, with four pieces of each length, width, and height.

3. Use an art knife to cut the mortise and tenon gaps in the pine wood, then combine them and stick them together with 502.

4. Cut another piece in the middle and create a glowing pattern on the other side of the insulation.

5. Make a rear frame and position the installation switch and charging plug in the rear frame.

6. After installing the LCD clock microcontroller, connect the wires and check if the circuit is correct. If the circuit can display normally, wrap all the wire ends with electrical tape.

7. Cut 4 more pine trees and increase the thickness to 3 layers.

8. Cut a piece of wood and install light beads on it to provide a light source for the right illuminated table. Stick the wood to the blank space on the other side, connect the wires, and then stick the lamp holder to the isolated blank space.

9. Cut a 1mm light wood chip to cover the size of the small hole on the right, and draw the pattern you want to shine on it. Cut out the pattern with an art knife and paint the back black to prevent light from shining through.

10. Cut six panels using light wood chips, draw auxiliary lines, and grind them to a 45 degree angle.

11. Grind the light wood chips thin until the light energy of the clock passes through the board, and then stick them on one by one.

12. On the back, the back panel is divided into an inner panel and an outer panel. A magnet is attached to the inner panel, and a charging port is dug out from the outer panel. A plastic pipe is attached to reinforce the charging port, and a small iron plate is attached. A homemade handmade wooden alarm clock is completed.