The nail artist who first learns to use an electric grinding machine should understand that the electric grinding machine is not used to make up for the clumsy. Compared with the sand stripe, the efficiency of the use of the nail polishing machine will improve a lot. If the manicurist who uses an electric grinding machine for the first time is to understand that the electric grinding machine is not used to make up for the clumsy. Compared with the sand stripe, the efficiency of the use of the nail polish machine will be improved a lot. If the manicurist's collection is very stupid, it is necessary to improve the technology first, rather than the problem that it is completely dependent on the electric grinding machine to solve. If you want to use an electric grinding machine flexibly, no matter how good the technology is using the sand strips, it takes a certain time. If you want to know the electric grinding machine, you must concentrate your energy and be willing to spend time. First of all, you must read the manual, familiar with the polishing machine and bricks. Practice the use of the polishing machine to be familiar with its power size, hold the handle, and adjust the high rate (the number of rotation of the polishing machine per second).

       The nail artist who often uses a nail polish machine can feel its power size. Paste the armor with glue on one end of the wooden stick. One hand holds the wooden stick, and the other hand's wrist is placed on the table for Hold the handle of the grinding machine in the gesture of the pen, and the wrists should be relaxed during work to balance your hands to better control the machine. Use columnar bricks and low -speed booting correctly, gently start from the right edge of the nails, and gradually slide to the left. When the brick touches the left edge of the nails, lifts the brick and then goes back to the right side from the right side. Do not heat the bricks. The service items are different, and the position of the lower bricks is also different. That is to say, if the manicurist is using a fine carbonized brick to repair the spike nails, it should be polished back and forth horizontally. The operation on the armor is that if you want to make a thin piece of pieces, the bottom of the brick is more appropriate. Pay attention to the place where the brick is produced. This can be seen what parts of the brick are used. Bricks are safer to use cone -shaped bricks. When pushing the finger skin, the upper part of the pushing brick is used to draw a perfect angle on the nails, so that it is in line with the natural armor. Use a pencil to draw a shadow mark in the area to be polished, polish on the mark, and observe the process (you can use alcohol or nail washing water to remove all the remaining marks)